4/2/2023 0 Comments Falco f8l spars![]() Further development of the basic design and the introduction of a 160 HP engine resulted in the current model the Super Falco manufactured by the Laverda S.p.A. The manufacturing licence was then acquired by Aeromere S.p.A who produced a version named F.8L America basically similar to the series II. It was built by Aviamilano in two different series, the first series powered by a 140 HP and the second with a 150 HP Lycoming O-320-A. Stelio Frati the F.8 Falco first flew on 15 June, 1955. ![]() Just replace the info in your F.8L "aircraft.cfg" file with this new info.ĭescription=Blue "Amelia" N5839F repaint by Tom Tiedman. ![]() Also below, find updated airshow engine smoke info for use in FSX, which changes the FS2004 smoke trails to a single trail coming from the starboard exhaust.Find this repaint in your airplane menu under Laverda (Aviamilano).Add info below to your Falco F.8L "aircraft.cfg" file, remember to change the "X" to the next number among your Falco F.8L repaints.Copy and paste (or drag and drop) the enclosed texture folder "texture.Blue N5839F" into your Falco F.8L airplane folder. ![]() The wing rib chord lines are drawn on the fore and aft faces, as well as the spar trim lines. Since the photo, that fitting has been installed as well. Screenshot of a blue and white Falco F8L in flight. Here is a photo of the front spar removed from the clamps after the epoxy has cured: The small hole to the right of the flange on the main spar is for the gear side load fitting. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |